Product Design

We offer the full spectrum of product design capabilities. We will accompany you from drawing up technical specifications based on your requirements to a fully functional product ready for volume production and will also build the various prototypes and initial production run.

We can also act as an extension of your design team in overload situations. We have experience of the following industry sectors:

  • Biomedical
  • Telecommunications
  • Industrial automation
  • Automotive
  • Process

Abiliies:

  • Hardware design
  • Schematic design
  • PCB layout and simulation
  • 3D CAD drawings
  • Embedded software design
  • FPGA -VHDL programming
  • Test and validation
  • ISO9001:2008 Quality system

Embedded systems

We are familiar with many of the most popular manufacturers for microcontrollers, FPGA (field programmable gate arrays), etc:

  • Microchip: one of the worlds most popular microcontroller manufacturers
  • Intel: Well known for top of the range chip
  • H: For volume production
  • ST microelectronics
  • Altera
  • Lattice
  • Xilinx

As part of the product design we will also take care of the power supply and any analogue signal processing required. So whether you need to measure at low speeds (a few samples per second) or very high frequencies (100MHz+) we have the knowledge and expertise to meet your requirements.

Available equipment includes:

  • Numerous oscilloscopes including Agilent MSO6104A 1GHz mixed signal oscilloscope
  • Logic analyser
  • Spectrum analyser
  • Signal & pulse generators, power supplies, etc.
  • PC Controlled DVMs for automated testing
  • Hi Pot & ground testers for safety testing.
  • HP6050A Electronic Loads
  • Racal  6103 Digital Radio Test Set

CAD

Our CAD systems include:

  • Pads PCB: PCB Layout software for high speed circuits
  • Pads Logic: Schematic capture
  • Orcad Design: Schematic Design
  • Hyperlynx: PCB signal integrity and analysis
  • SolidWorks: 3D Modelling package with sophisticated analysis capabilities
  • OneCAD: CAD Software with post processor to drive CNC Mill

Why use several external partners when one will do the job?